4/2/2024 0 Comments Dynatorch plasma table priceI surface the parts when they are still on the sheet and remove all dross and then break them off. I should also mention it has a footprint of 72" x about 40" deep, 5 feet high-ish.īelow is an image of about two days of cutting both 12g 304 and. Nitrogen is a good thing to use for stainless. I weld up long 12' pieces by indexing them and you cannot tell where the weld was. Paid for itself seven times over at least. I have about six hundred hours on it now and still cuts like the day I bought it. The software is now near perfect and was not two years ago when I got my machine. Because it is pulsed fiber, it never needs anything replaced except for a small lens about every 200 hours. It plugs into a 115VAC outlet and the 4.5KW machine will cut 1/4" stainless albeit slowly. If you have a flexible budget please consider a Fablight Pulsed Laser.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |